Guest 0 item(s)

Electriduct Heat Shrink Breakout Boots

Electriduct Heat Shrink Breakout Boots
Electriduct Heat Shrink Breakout Boots  

Made from radiation cross-linked polyolefin, these Heat Shrink Breakouts are suitable for single to multiple, or multiple to multiple wire connections. Each Heat Shrink Boot is UV resistant and has a hot glue ribbed liner on the inside to create air tight seals.

The shrink boots material and design make it perfect to seal crutch electrical connections that need superior insulation and water protection while providing strain relief on cable terminations.

Minimum shrink temperature: 110°C
Minimum full recovery temperature: 130°C
Shrink Ratio: 3 to 1
*Shrink Ratio: 2 to 1 (HSB-5-1.5)
Max Voltage: 1000

Shrink ratio may vary ±2%

Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #: Price: $
Part #
Price$3.50
Quantity:
4 Stars
Audio Engineer
I use these for custom powered speaker cables. They are pretty stiff but offer a very professional look and great protection from the abuse of stage life. I look forward to using more of them.
Did you find this helpful?  1 of 1 Found Helpful
Reviewed by:  from California. on 12/15/2014
4/5
4 Stars
Engineer
Last time I have purchased a dozen of HSB-2-1 Boots for our Hi-End Speaker Cable project. I might say that for the price these boots are very good deal. They shrink nicely and remain very flexible after shrinking. They also seem to be pretty strong. From the functionality stand point these boots are more than adequate for their task. We will definitely buy them again.
Did you find this helpful?  1 of 1 Found Helpful
Reviewed by:  from . on 11/14/2011
4/5
5 Stars
Live Sound Engineer
This product works as advertised. I used it to create a set of custom audio cables to run from the main power amps to the on-stage FOH speakers. Everyone keeps asking where I bought the breakout cables. My completed project looks like it was molded at the factory. Great Product!
Did you find this helpful? 
Reviewed by:  from Nashville, TN. on 2/15/2012
5/5
Back To Top